港口罢工对周边空气质量的影响

港口污染物的排放浓度极大地影响着周边的空气质量,以2013年3月28日香港国际集装箱码头发生的罢工事件为契机来探究港口运作短暂的瘫痪对周边空气质量的影响。首先,进行污染物之间的相关性分析确定影响本次罢工事件的污染物主要为NO_2、NO_x、SO_2以及O_3。其次,基于罢工前、罢工期间以及罢工后污染物排放的浓度变化,进行横向对比发现罢工期间的污染物确实有一定程度的减少。再次,利用纵向对比排除四季带来的影响探究不同年份同一阶段污染物浓度的变化情况评估罢工期间的空气质量。最后,以NO_2为例建立预测模型对罢工期间的NO_2浓度进行预测,根据实际值与预测值之间的差异来说明罢工影响了NO_2的预测趋势。这项研究主要强调港口空气质量对整个环境的影响,在一定程度上说明政府实施政策的有效性,为政府提供了决策支持,同时也要注重污染物之间的相互转化作用对环境的影响。     

Ti/SnO_2-Sb阳极-空气阴极电催化降解染料废水

为解决电化学法处理高盐染料废水存在的能耗大、成本高等问题,分别采用溶胶-凝胶法和辊压法制备Ti/SnO_2-Sb阳极和空气阴极,构建了Ti/SnO_2-Sb阳极-空气阴极双极体系(TSSA-ADC)。甲基橙(MO)作为高盐染料废水的典型污染物,考察了电流强度、MO浓度、电解液浓度和初始p H对TSSA-ADC体系和TSSA单阳极体系降解MO的影响。结果表明:与TSSA单阳极体系相比,TSSA-ADC体系具有更好的抗有机负荷冲击、抗盐分冲击、抗酸碱波动能力,能够维护酸碱平衡防止硬度离子结垢。最佳反应条件为电流强度为0.030 A,电解液浓度为3%,MO浓度为100 mg/L,初始pH=6。以MO去除率达到98%为基准,TSSA-ADC体系比TSSA体系可节能74.26%。     

利用餐厨垃圾湿热处理脱出液制备液态菌肥研究

以餐厨垃圾湿热处理脱出液为发酵培养基,选用圆褐固氮菌(Azotobacter chroococcum)作为实验菌种制作固氮液态菌肥。测定了圆褐固氮菌的主要生理特性,将其接种于餐厨湿热处理脱出液中进行培养,确定最佳发酵时间,并分别测定发酵的最佳初始p H值、接种量、培养温度、摇床转速、装液量、脱出液与水的混合比例。结果表明:圆褐固氮菌在餐厨湿热处理脱出液中最佳发酵时间为36 h,发酵最佳初始p H值、接种量、培养温度、摇床转速、装液量、脱出液与水的混合比例依次为7.5、1%、30℃、150 r/min、50 m L(250 m L锥形瓶)、1∶1。圆褐固氮菌在餐厨垃圾湿热处理脱出液中进行培养后,可达到液态菌肥的活菌数标准。     

复合生物阴极型微生物燃料电池处理废水及同步产电性能

为研究生物阴极在MFC（微生物燃料电池）中的应用,分别以粒径为2~4 mm的颗粒活性炭和粒径为2~4、4~8、8~12 mm的颗粒石墨为阴极基质材料,构建升流复合生物阴极型单室MFC,研究阴极基质材料的种类和粒径对MFC的产电性能和净水效能的影响.结果表明:当阳极基质材料为2~4 mm粒径的颗粒活性炭时,燃料电池中利用玻璃纤维取代离子交换膜,阴极基质材料为选用4~8 mm粒径颗粒石墨的反应柱产电量最大,为534 mV（外电阻为1 000 Ω）,最大功率密度达到631.6 mW/m3,库伦效率为3.82%;阴极的pH越低越有利于阴极的产电反应;不同阴极基质材料的MFC对COD_Cr去除率均在80%左右,TN、NH₄+-N及TP的去除率最高可分别达到79%、93%和34%.研究显示,阴极基质材料的种类和粒径对MFC的产电性影响较大,但对其净水效能的影响不大.      

CHO cell cytotoxicity and genotoxicity analyses of disinfection by-products: An updated review

The disinfection of drinking water is an important public health service that generates high quality, safe and palatable tap water. The disinfection of drinking water to reduce waterborne disease was an outstanding public health achievement of the 20th century. An unintended consequence is the reaction of disinfectants with natural organic matter, anthropogenic contaminants and bromide/iodide to form disinfection by-products (DBPs). A large number of DBPs are cytotoxic, neurotoxic, mutagenic, genotoxic, carcinogenic and teratogenic. Epidemiological studies demonstrated low but significant associations between disinfected drinking water and adverse health effects. The distribution of DBPs in disinfected waters has been well defined by advances in high precision analytical chemistry. Progress in the analytical biology and toxicology of DBPs has been forthcoming. The objective of this review was to provide a detailed presentation of the methodology for the quantitative, comparative analyses on the induction of cytotoxicity and genotoxicity of 103 DBPs using an identical analytical biological platform and endpoints. A single Chinese hamster ovary cell line was employed in the assays. The data presented are derived from papers published in the literature as well as additional new data and represent the largest direct quantitative comparison on the toxic potency of both regulated and emerging DBPs. These data may form the foundation of novel research to define the major forcing agents of DBP-mediated toxicity in disinfected water and may play an important role in achieving the goal of making safe drinking water better.     

Predicting vehicle fuel consumption patterns using floating vehicle data

The status of energy consumption and air pollution in China is serious. It is important to analyze and predict the different fuel consumption of various types of vehicles under different influence factors. In order to fully describe the relationship between fuel consumption and the impact factors, massive amounts of floating vehicle data were used. The fuel consumption pattern and congestion pattern based on large samples of historical floating vehicle data were explored, drivers'' information and vehicles'' parameters from different group classification were probed, and the average velocity and average fuel consumption in the temporal dimension and spatial dimension were analyzed respectively. The fuel consumption forecasting model was established by using a Back Propagation Neural Network. Part of the sample set was used to train the forecasting model and the remaining part of the sample set was used as input to the forecasting model.     

金属尖化前缘模型主动式热疏导性能试验研究

目的为了更好地解决高超声速飞行器舵、翼前缘及头锥等气动热环境恶劣区域的热防护问题。方法采用主动式热疏导技术,以高温液态合金为工质,设计并制作具有主动式热疏导功能的尖化前缘金属试验模型(R=5 mm)。根据模型外尺寸设计加工一套石英灯仿形加热器和热流测试模型,开展地面热环境模拟试验。结果试件在前缘中心温度530℃左右时具有瞬态启动特性。前缘中心和大面积中心最大辐射热流密度分别为1000 kw/m^2和580 kw/m^2,试件在该环境中长时间受热状态下仍具有较好的热疏导能力。试验后试件无工质泄漏和结构破坏,具有一定的可重复使用性。结论可以此热疏导方式结合现有成熟热防护技术进一步开展工程设计与应用。     

NO参与铝诱导蚕豆保卫细胞死亡的调控

铝(Al)是地壳中含量最丰富的金属元素,是酸性土壤中导致植物生长抑制和作物产量下降的一个主要因素,但铝毒性作用机制尚不清楚.本文以蚕豆叶表皮为材料,研究铝胁迫对气孔保卫细胞活性的影响,探讨NO在铝诱导细胞死亡中的作用.结果表明,一定浓度的A1Cl3可诱导气孔保卫细胞活性降低,部分细胞死亡,且随着铝浓度的增高细胞死亡率增高.死细胞呈现核固缩、核崩解、凋亡小体等典型凋亡特征,且凋亡抑制剂Z-Asp-CH2-DCB能阻止AlCl3诱发的细胞死亡.用NO清除剂c-PTIO、NO合酶抑制剂L-NAME或硝酸还原酶抑制剂NaN3降低铝处理组胞内NO后,细胞死亡率显著降低,胞内ROS、Ca2+水平同期降低;NaN3还能降低铝处理组中具有程序性死亡特征的细胞比率.用ROS清除剂AsA清除铝处理组胞内ROS后,细胞死亡率显著降低,胞内Ca2+和NO水平亦显著降低;铝处理液中加入Ca2+通道抑制剂LaCl3后,细胞死亡率低于铝单独处理组,胞内ROS和NO水平无明显改变.研究结果表明,铝胁迫引起的胞内NO合成增加通过Ca2+信号途径介导了保卫细胞的程序性死亡.     

氟虫双酰胺在水稻和稻田中的残留动态研究

采用超高效液相色谱法(UPLC)测定了氟虫双酰胺19.8%悬浮剂(SC)在水稻及稻田环境中的残留动态.结果表明,当氟虫双酰胺及其代谢产物NNI-des-iodo的添加量为0.05～1.0 mg·kg-1时,其在水稻田土壤、田水、稻秆、稻米和稻壳中的平均回收率为78.2%～104.8%,变异系数为1.1%～4.4%.氟虫双酰胺在2011年三地(福建福州、天津、江苏南京)的稻田水中的降解半衰期为9.8～17.3 d,土壤中10.8～22.4 d,植株中7.6～17.3 d,其在稻田水样品中检出了代谢产物NNI-des-iodo,而在土壤和植株样品中未检出.在推荐使用剂量下,于末次施药10 d后,氟虫双酰胺在水稻稻米中的残留量均低于美国规定的在稻谷上的最大残留允许量(0.5 mg·kg-1).     

羧基化碳纳米管载铂催化剂对微生物燃料电池阴极氧还原性能的影响

阴极催化剂是影响微生物燃料电池(microbial fuel cell,MFC)性能的关键要素.为了考察不同羧基化方法改性的碳纳米管(carbon nanotube,CNT)负载Pt的催化氧还原效率,分别在80℃和95℃条件下对CNT进行了羧基化,采用浸渍-沉淀法制备了Pt/CNT催化剂(Pt/CNT-80和Pt/CNT-95),并在空气阴极MFC体系中验证了其催化氧还原效果(MFC-80、MFC-95和MFC-C).结果表明,MFC-95和MFC-80的最大功率密度分别为568.8 mW.m-2和412.8 mW.m-2,内阻分别为204.7Ω和207.7Ω,开路电压分别为0.719 V和0.651 V.而对照MFC-C的最大功率密度仅为5.4 mW.m-2,内阻为826.2Ω.XPS和XRD分析结果显示,Pt/CNT-95催化氧还原效果优于Pt/CNT-80,原因可能是95℃羧基化过程在CNT表面引入了丰富的含氧基团.